The 44727A is a 4-channel (voltage) digital-to-analog converter. Each channel can be configured using finger-movable jumpers to output either unipolar or bipolar voltage. This plug-in module is designed for use with the 3852A Data Acquisition and Control Unit.
Read More
44704A High Speed 16-Bit A to D card for use with the 3852A Data Acquisition and Control System. Directly measures: dc voltage; resistance.
Read More
Used with 3852A Data Acquisition/Control Unit 5 1/2- to 3 1/2- Digit Integrating Voltmeter directly measures DC voltage, AC voltage and Resistance. The 44701a lets you accurately measure small signal changes in noisy environments. You can choose the resolution, accuracy and noise rejection needed while maximizing measurement speed. You can also optimize resistance measurements to the accuracy you need. Best dc voltage accuracy: +/-(0.008% + 8uV) for 3V range.
Read More
The Agilent 44476A is a microwave switch module. There are three independent SPDT 50 Ohm coaxial relays with excellent electrical performance from DC to 18GHz. For general purpose microwave switching applications, the module can be used to switch separate signal sources for a multi-band receiver/transmitter testing application. The 3-mm SMA connectors on the module edge allow ease of wiring.
Read More
The 44422A Relay Multiplexer with Thermocouple Software Compensation is for use with the 3497A Data Acquisition. It consists of reed actuated relays that switch High, Low, and Guard on each of twenty channels. Inputs to the relay card are provided by terminal connector cards, one of which has thermocouple compensation built in.
Read More
The 43961A RF Impedance Test Kit provides the capability to measure impedance parameters of 1-port devices with the 4395A Option 010 (100 kHz to 500 MHz ) or the 4396B Option 010 ( 100kHz to 1. 8Ghz ). The test port or the 43961A is a 7-mm connector and can be used with the 16191A, 16192A, or 16193A test fixture. The 43961A includes open/short/load calibration standards, and the test fixtures such as 16192A are optional.
Read More
The Agilent 438A power meter is a dual-channel power meter designed specifically for ATE systems. The compact front panel saves critical rack space, while the dual-channel design allows simple and accurate measurements of the ratio and difference of power levels from two separate sensors. This meter is compatible with the 8480 series of power sensors. GPIB capability is standard on the 438A. For U.S. Air Force Modular Automatic Test Equipment (MATE) system application, Option 700 provides the 438A with the internal capability to be controlled by the MATE Control Interface Intermediate Language (CIIL).
Read More
The 4352A is normally used with a low noise signal generator to make up a 4352S test system. This system can evaluate the characteristics of VCOs and PLLs that are essential to designing local oscillators used in RF wireless communications equipment. This system can operate in either Signal Analyzer or VCO tester modes up to 3 GHz. The 4352A provides and controls all of the signals (DC control voltage, DC power and 1 kHz modulation) that are required to test the VCO/PLL.
Read More
The Agilent 43521A Downconverter Unit is designed to operate with the Agilent 4352S VCO/PLL signal test system. When configured with the Agilent 43521A downconverter unit, the Agilent 4352S offers a dedicated and comprehensive VCO/PLL design and production measurement solution for manufacturers that must test at frequencies above 3GHz. The enhanced Agilent 4352S is a complete system that offers a frequency range from 10MHz to 12.6GHz and is capable of measuring phase noise, RF power, transients, settling time, and many more parameters required for VCO/PLL evaluations.
Read More