The Keithley Model 580 is a 4 1/2-digit resolution autoranging micro-ohmmeter with a ±20,000 count LCD. This unit is designed for low resistance measurement requirements from 10µOhm to 200kOhm. The model 580 has an analog output/IEEE-488 interface option, Model 5802.
Read More
The Keithley Model 2400 SourceMeter® is a 20W instrument that allows sourcing and measuring voltage from ±5µV (sourcing) and ±1µV (measuring) to ±200V DC and current from ±10pA to ±1A. It’s well-suited for testing a wide range of devices, including diodes, resistors, resistor networks, active circuit protection devices, and portable battery-powered devices and components. It’s also useful for systems power sourcing and I DDQ testing applications.
Read More
The LCR-817 is a high-end digital LCR Meter for component/material measurements, applicable to various R&D activities and assembly lines. The large 240 x 128 dot matrix LCD display provides ample room for two measurement items and setup parameters allowing to grasp measurement results quickly. All test modes are able to measure supplementary factors such as, R/Q, C/D, C/R and L/Q.
Read More
The Instek GPC-3030D is a triple output, 195W, linear DC power supply. Channels 1 and 2 are fully adjustable (model dependant) and Channel 3 is fixed at 5V/3A with ripple and noise at less than 2mVrms. Overload and reverse polarity protection keep GPC-3030D and its load safe from unexpected conditions. The GPC3030D features continuous or dynamic internal load selection and series or parallel tracking for application flexibility. The GPC-Series is an ideal solution for inexpensive bench-top applications requiring low noise and multiple outputs.
Read More
The HP/Agilent N4416A S-parameter test set is a key component of an Agilent physical layer and balanced-measurement system. When combined with an Agilent PNA Series E8356A, E8357A, or E8358A. Option 015 vector network analyzer and an external PC equipped with an IEEE-488 GPIB card, this test set makes characterizing high-speed digital interconnects as well as, fully balanced or balanced-to-single-ended RF components a lot easier.
The N4416A S-parameter test set requires the N4425A Balanced Measurement System software or the N1930A Physical Layer Test System software for control of the 4-port VNA system, calibration, and data display and analysis.
Read More
- Frequency range from 15 MHz – 3.35 GHz
- Two output channels
- Low jitter
- Fast rise times (20%-80%) < 60 ps
- Delay modulation (jitter emulation)
- Variable cross-over point (eye deformation) LVDS applications can be addressed with output levels from 50 mV to 2 V Pre-/de-emphasis and squelch levels for PCI Express and serial ATA
- LVDS applications can be addressed with output levels from 50 mV to 2 V
- Pre-/de-emphasis and squelch levels for PCI Express and serial ATA