The Fluke OFP-100-M Optifiber Pro OTDR allows for testing and troubleshooting of multimode fibers at 850nm and 1300nm wavelengths. Used in conjunction with the DSX-800 and SmartLoop, the OFP-100-M allows the user to test two fibers with a single test! The Fluke OFP-100-M weekly rental kit consists of the OTDR module and two launch fibers.. The renter can specify the type of connector required. Connector choices include SC, FC, LC or ST.
Must be used in conjunction with the DSX-8000.
Note: Photo shows SC Connector Option and Quad Module
Read More
Includes OEM Calibration.
The Agilent HP Keysight E4413A diode power sensor, with wide dynamic range, is designed for use with the EPM and EPM-P series power meters for power measurements on CW signals from 50 MHz to 26.5 GHz. The E4413A power sensor provides extremely low SWR to minimize the source and sensor mismatch errors. Also, for comprehensive error correction, the calibration factors, linearity and temperature error-correction information are stored in EEPROM. The sensor’s power measurements are traceable to the U.S. National Institute of Standards and Technology (NIST).
Read More
Keysight Agilent basic DC power supplies offer essential features for a tight budget. The multiple output, 35-50 W, E3620A and E3630A provide dual and triple outputs; small, compact size for bench use; low-noise and excellent regulation; and overload indicator to monitor output. The Agilent 50W, dual output E3620A has two clean, reliable outputs for general purpose application; and is compact, affordable for versatile benchtop testing.
Agilent HP Keysight E3620A 50W Dual Output Power Supply, Two 25V, 1A
Read More
The UFX-BER series is fully automated and sets accurate C/N ratios over a wide range of signal power and frequency ranges. This set has an 836 MHz carrier frequency.
Read More
The Agilent 34905A RF multiplexer module for the 34970A Data Acquisition/Switch Unit offers broadband switching capabilities for high-frequency and pulsed signals. Use it to route test signals between your device under test and your signal generator, oscilloscope, spectrum analyzer, or other instrumentation. The RF multiplexers are arranged as two independent 1 x 4 multiplexers, each with a common shield and a switched center conductor. Connections can be made directly to SMB inputs with 2 GHz usable bandwidth, or to the BNC-to-SMB adapters provided with 1 GHz bandwidth. Multiple banks may be cascaded together for applications requiring even larger topologies– create a stubless 16:1 multiplexer in a single frame.
Read More
60 V
– 1.65 A
– Load Regulation(CV): 0.006% + 0.75 mV
– Line Regulation(CV): 0.004% + 0.75 mV
– Line&Load Regulation(CC): 0.01%
– Metered
– Programmable
Read More