The Tektronix P6247 enable users to make time domain or frequency domain measurements on high bandwidth signals commonly found in disk drive, digital IC design (RAMBUS) and communication applications (Gigabit Ethernet, IEEE-1394 Firewire and Fibre Channel). The small probe head geometry and assorted probe tip accessories allow these probes to easily accommodate manual probing of surface mount devices while maintaining high CMRR. The P6247 are ideal for design verification of disk drive read channel electronics and timing analysis for troubleshooting ground bounce problems associated with high speed logic. They can also be used for pulse shape or cross talk compliance testing of high speed communication signals.
Read More
Includes Option 00F
The Agilent N4693A MW electronic calibration (ECal) module makes calibration of vector network analyzers fast, easy and accurate. The RF ECal system is now easily controlled by one of two methods depending on the network analyzer. The Agilent PNA and ENA series of network analyzers controls the module directly via the USB interface. The modules can also be controlled via an 85097B interface kit when used with an Agilent 8753E/ES/ET or 8720D/ES/ET. (This requires a special parallel cable and firmware Rev. 7.74).
ECal is an ideal solution for calibrating network analyzers. Performing a full two-port calibration takes less than half the time and number of connections using ECal versus mechanical cal kits. Furthermore, the accuracy of the calibration is comparable between electronic and mechanical methods. Traditional mechanical calibrations require intensive operator interaction which is prone to errors. With ECal, the operator simply connects the ECal module to the network analyzer and the software controls the rest.
Read More
The TDS5000B Digital Phosphor Oscilloscopes (DPO) deliver 350 MHz, 500 MHz, or 1 GHz bandwidth, 5 GS/s real-time sample rate, up to 16 M record length, and a suite of advanced triggers, enabling you to capture and characterize even your most demanding signals. DPOs provide unmatched insight into signal behavior by displaying, storing, and analyzing complex signals in real time using three dimensions of signal information: amplitude, time, and distribution of amplitude over time.
Read More
Includes Option 10G
The 80A05 Electrical Clock Recovery Modules enable clock recovery for electrical signals. Additionally, the 80A05 provides internal routing of the recovered clock for triggering of the 8200.
The 80A05 provides high level of integration and the best sensitivity available, and is the optimal solution for testing of optical transmitter components and electrical components of optical systems. The 80A05 PLL loop bandwidth selection is automatic with no interaction, leading to easy setup and operation.
Read More
The high bandwidth (500 MHz) of the TDS714L together with its sample rate (500 MS/s) shows the true signals that other scopes may be missing.
The TDS714L provides a wide dynamic range, flat response, fast overdrive recovery, calibrated DC offset, 1-mV/div sensitivity, 1-ns peak detect, and internal calibration.
Options 13, 1F, 1M, 2F
Read More
-41.5% Accuracy
-100 MS/s Sample Rate
-2 and 4 Channels
-Record Lengths to 120 K (Opt. XL)
-Floppy Disk Storage
-Roll Mode Allows You to See Acquired Data Points Without Waiting for the Acquisition of the Complete Waveform
-Use the Video Trigger Mode to See NTSC, PAL, SECAM Signals or Your Own Custom Video Signals
-Capture Those Glitches with the 10 ns Peak Detect Mode