Tektronix SD46; 20GHz Bandwidth; 1100 to 1650nm wavelength; Connectors: FC/PC input, 2.92mm (K) output. For use with the CSA803A/11801B. Linear up to 25nW peak input with a calibrated deflection factor from 50µW/div. to 5mW/div at 1300nW.
Read More
The Agilent R11644A calibration kit contains the precision mechanical standards required to calibrate the systematic errors of Agilent network analyzers. This calibration kit has a precision airline for performing the Thru-Reflect-Line (TRL) calibration, the most accurate error-correction technique for coaxial measurements. This kit also contains flush short circuit, a precision shim, and a fixed termination.
Read More
The Agilent Q347B noise source covers a 33 to 50 GHz frequency range. This waveguide noise source allows you to make accurate and convenient noise figure measurements on millimeter-wave devices. The Q347B provides highly precise broadband noise at the input of the system or component under test. The noise figure meter then processes the ON/OFF ratio of noise power present in the system IF, and provides an accurate reading of noise figure and gain. The Q347B noise source has remarkable ENR stability over time, which allows longer recalibration cycles and more accurate noise figure measurements.
Read More
The Agilent Q281B is a 2.4 mm male to WR-22 waveguide adapter that operates in the 33 to 50 GHz frequency range. These adapters transform waveguide transmission lines into 50 ohm coaxial lines. Power can transmitted in either direction, and each adapter covers the full frequency range of its waveguide band with SWR less than 1.3.
Read More
The Agilent Q281A is a 2.4 mm female to WR-22 waveguide adapter that operates in the 33 to 50 GHz frequency range. These adapters transform waveguide transmission lines into 50 ohm coaxial lines. Power can transmitted in either direction, and each adapter covers the full frequency range of its waveguide band with SWR less than 1.3.
Read More
The Tektronix P6982 is recommended for applications requiring full differential with the best signal density for data rates in excess of 750 MHz (TLA7Bxx) or 450 MHz (TLA7Axx) when the LA is acquiring in half channel mode and a quick connect to a small footprint is needed.
Read More
The Tektronix P6810 is recommended for most general-purpose applications where signal integrity is critical.
Read More